3000
- Pneumatic actuator
- 22-gauge steel housing. Mechanically sealed and gasketed, leak resistant construction.
- 3/4" Dual density internal insulation, coated to resist air erosion. Meets
requirements of NFPA 90A and UL 181.
- Tight close-off damper. Leakage is less than 2% of nominal cfm at 3"wg as rated by
ARI-880.
- Rectangular discharge opening is designed for slip-and-drive cleat duct connection
- Multi-point averaging flow sensor.
- Controller set for Direct Acting / Normally Open
- Gauge tees for cfm measurement.
Available sizes:
| Inlet Size |
Total cfm Range |
| 6" |
0-500 |
| 8" |
0-1000 |
| 10" |
0-1425 |
| 12" |
0-2200 |
| 14" |
0-2700 |
| 16" |
0-3600 |
| 24" X 16" |
0-8000 |
Accessories:
- 2-row hot water coil
- Direct or Reverse acting thermostats
Replacement Control Accessories:
- Nailor 3000 Velocity Controller
- Nailor 2000 Velocity Controller
- Johnson Pneumatic Operators (5-10 psi)
- Pneumatic Operators (5-10 psi)
Single Duct Terminal Units are available with pneumatic controls, electronic controls,
and analog controls. Units are also available with standard internal insulation or
full metal liner option for "IAQ" sensitive applications. Ideally suited
for hospitals, clean rooms, and animal labs.
| Hahn-Mason Home | Warehouse | Fans |